AIM Motorsport MXG 1.2 Racing Dash Data Logger & GPS Module 
 
The Aim MXG 1.2 Racing Dash Data logger is designed to acquire and display data coming from your ECU, the internal accelerometer and gyro, as well as from the GPS08 Module included in the kit, analog/digital inputs and predefined math channels.
A Wide Range of Data Sources
Performance and data acquired can also be incremented adding up to eight expansion modules. The only difference between the two is the MXS is a compact 5″ display and Aim MXG 1.2 is a 7″ display, a better fit for wide cockpit installations.
 
CAN Output
With the CAN Output you can send messages directly to an existing CAN network in order to improve the range of vehicle control possibilities.
 
Freely Configurable Pages
You can define all the custom pages you wish, choosing among a wide library of page styles, defining which data to be shown, their end of scale and measure units. Swapping between pages can be managed pushing one or two push buttons.
 
 
High Contrast 7″ TFT display
The MXG 1.2 Racing Dash Data logger features a high contrast 7″ TFT display, fully configurable by a dedicated software. An ambient light sensor keeps the backlight at optimum brightness levels.
 
 
Flexible Alarms
MXG 1.2 features eight configurable RGB alarm LEDs: you choose the conditions, you choose the colors. Select a solid alarm or flashing one - and the flashing frequency, choose to have an accompanying text message, and set the alarm priorities.
 
Two Digital Outputs
 
Aim MXG 1.2 Racing Dash Data logger features two digital outputs. Each of them can give an output of 1 amp at 12 volts: they can be configured in order to be turned on/off depending on the value of the analogue or digital inputs. They permit to automatically run external systems, i.e. to switch on/off additional lights, to activate/de-activate a cooling fan or circulation pumps, etc. when a certain event happens.
 
 
Integrated Shift Light Array
 
Choose from a host of advanced multicoloured RGB shift light patterns that can be customised to your liking, and for each unique gear when required. Using the built-in CAN bus, you can add expansion modules to the Aim MXG to increment the performance and the data acquired.
 
 
Expand the system, according to your needs
 
Using the built-in CAN bus, you can add expansion modules to the MXG 1.2 to increment the performance and the data acquired:
 
 
GPS08 Module
 
 
Thanks to GPS08 Module (included in the kit) and its Race Studio 3 software, you can immediately get laptimes and all data needed for engine tuning as well as for improving driving technique.
 
Channel Expansion
 
 
It permits to add 4 0-5Volt analog channels for pressure, temperature sensors and potentiometers. Two of these channels can be configured to receive digital inputs like wheel speed.
 
TC Hub
 
 
It adds 4 K thermocouples.
 
LCU-One CAN
 
 
Wide band Lambda controller LCU-One, with Bosch LSU 4.9 probe, providing all Air/Fuel data and lambda value, allows to perfectly tune the carburetion.
 
SmartyCam HD cameras
 
The on-board cameras that overlays on videos the data sampled by your logger.